Winter - the perfect time of year, but for some representatives of fauna, particularly birds, which do not fly south, it becomes an ordeal due to the fact that all food produce is becoming difficult.
To facilitate the feathered winter, I offer to make them a bird feeder and always connected to the child - it is very important to the baby from childhood have learned to properly treat nature.
Bird feeder can be made from it anything - wood, plastic bottles, cardboard boxes or packages.
We'll be tinkering of waterproof OSB plates. Besides, we need: tape measure, hammer, screwdriver, hacksaw on wood, building square, flat brush, electric drill, nails, self-tapping screws for wood, wooden board and batten.
First we need to draw a diagram. Should not limit your imagination, because the bird feeders can be implemented in virtually any form, as long as it meets the following criteria:
• Reliability and durability. When choosing the material and the fixings for feeders, keep in mind that they must bear the weight of the feathered guests;
• Resistant material. To feeder birds happy with you and for a long time, produces it from such materials, which are not deformed by precipitation;
• Security. Do not place the bird feeder in guschah branches, heavily flushed zone, as well as places where cats can get. To attract the attention of birds, hang a bird feeder in the open and clearly visible area.
As a master: We start with a plate - base (bottom) of our birdhouse. Its dimensions are 300 x 300 x 12 mm. Transfer them to a plate, using a square. Do not forget to check the diagonal! Cut the preform with a hacksaw.
It turned out like this:
The next step of - cutting the blank for a bead. We use rail 15h30mm size. Requires four rails: 2 pieces of 300 mm. 2shtuki to 270 mm.
Slats nailed to the plate on the perimeter, using a hammer and nails 25 mm long.
Proceed to the base of the roof on the rack. For her use rail 15h30 mm. Cut the four blank of 160 mm.
As the material of the carcass for roofing board using a size 120 x 20 x 260 mm. Cut two pieces (individual roof angle).
Putting frames and racks into a single structure.
Fasten two elements to the finished bottom, using a secure connection to a self-tapping screw in wood.
For the manufacture of the roof, we used a wooden board (bunk), which were left trimming we renovated the house. The size of one roof half turned 350 x 200 mm.
Nailed to the roof frame and fasten the top rail 20 x 20 x 560 mm. Feeder is ready!
To add "flavor" to our creation, we decided to paint a bird feeder waterproof acrylic paint. Now we pour to weaning, and we hope that our little feathered friends will be satisfied!
