Water manicure is rightly called the most original and fascinating of all. It is distinguished by subtle transition of colors, spectacular complex patterns and inexpressible softness lines. Create the beautiful nail-design today under the force of any fashionistas, because the only difficulty Water manicure - the duration of its execution.
Water manicure: the principle of creation and the necessary tools
The aqueous based nail varnishes is the ability to form on the surface of warm water film. If you drop any nail-composition from a low altitude over the water, it will spread a thin layer of varnish.
Each subsequent layer - a contrasting color, as is customary in aqueous manicure - will also be spread in the water, without mixing with other colors and creating clear boundaries with them. And even forced connection lacquers will not lead to a loss of color purity, and only create more complex patterns on the film surface. This film will be the basis of an aqueous manicure.
Understand the principles of how to make water a manicure, it is easy to pick up tools and accessories therefor; grasp the essence of the phased implementation of technology. For water manicure need:
- varnish - colorless for the base and a few colored to create contrast patterns;
- Removers liquid - for adjusting the finished coating;
- cotton buds and toothpicks - to perform delicate work;
- conventional film tape - can be replaced very fat on the composition of the cream;
- a container of water - with a wide neck diameter.
How to make water a manicure at home?
Appliances Water nail-design is simple in execution, but requires a lot of time. It should be adjusted for continuous operation and highlight the manicure on the water about a half to two hours.
The first step is the preparation, during which the nails are put in order the usual hygiene manicure with a polishing of the nail plate. Fingers around the nails, but not touching them, thickly smeared with fat cream. Or tightly wrapped with tape, leaving accessible only the surface of the nail. Sami nails covered with transparent base composition.
A further algorithm to create a water nail polish is performed for each nail with full respect for each stage:
- In warm water (slightly above room temperature) with the height from the surface of 1.5-2 cm was dropped from a brush lacquer. Droplet spreads, creating a thin film. Once this occurs, in the middle of the film is dropped even a drop of nail polish - different, contrasting color. The procedure can be performed several times, creating circles of different colors on the surface of the water. If desired, lacquers "stirred" toothpick until the complex chaotic patterns. All actions should be done within minutes.
- In the chaos colored lacquer pattern selected most attractive place - this will be an aqueous nail coating to the nail. The finger is dipped into the water plane parallel to the water so that the film is completely covered nail. Holding hand in water, another gently collected lacquer film from the liquid surface. The easiest way to do this, if the "wind" varnish on a toothpick.
- The finger is removed, and wait for complete drying of the lacquer coating.
Actually, this is the manicure water generated patterns rasteksheysya colored lacquers. Further nails are put in order: adhesive tape is removed, the excess lacquer is removed dipped in nail polish remover wand. Self manicure further coated top.
Water belongs to the fancy manicure and original nail-technician, as each nail is obtained by a unique pattern. Understand the principle of the appearance of the film, as well as the algorithm of "sticking" ornament on the nail, you can get really spectacular combinations and interesting nail decorations.
