Certainly every other housewife faced burnt fabric on the iron. Therefore, we offers small todayagaem you 5 easy ways to clean the iron folk ways.
It is best to use special means that are suitable for purificationvarying the surface, but it happens that an urgent need to clean the iron, so you have to use what is at hand. Just keep in mind that people's means you can not clean all the irons, as some surfaces can spoil abrasive or acid.
How to care for different types of irons?
Aluminum soleplate. Aluminum is a very soft soft metal, so abrasive materials, such as soda or salt can easily scratch it, which means that you can not use this method of cleaning.
Stainless steel.This iron is unpretentious and can be cleaned in any way, but remember, the more scratches on it will be, the faster it will become contaminated.
Ceramic soleplate.These irons should be carefully to operate, and in no case do not clean with abrasives. Use special tools for cleaning or acid, such as vinegar.
Teflon coating.Expensive irons Teflon coated must be cleaned exceptionally special means for cleaning and not experiment with soda or vinegar. Therefore it is better to wait than to spoil the expensive equipment.
6 ways to clean iron
Salt.This the method is quite simple, but there are several important conditions, firstly, you need to take only the fine salt, not large, and secondly, this method is only suitable for those irons that can be cleaned with abrasive.
How to clean? Take a cloth, sprinkle it 2-3 mm layer of salt, heat the iron and run it a few times on the salt. If the fabric is not far behind with burnt with an iron at once, it is better not to experiment, and once again not to scratch the iron salt.
Paraffin candles.This method is suitable in the case of pollution on the iron fresh and of not very much. This way you can try to clean the iron with any sole.
How to clean? Small candle wrap cloth to wax your hands are not burned, Iron good warm up and put on the soles of the wax and wait until it cools down and wipe with a soft cloth.
Vinegar. Such a method cleans old contamination, it is relatively cheap and safe, but it is better not to experiment, and to begin to test the effect of vinegar on a small area of the soleplate.
How to clean? Vinegar, dilute with water 1: 1, in the obtained wet cotton pad thrust and wipe the sole. If the stains are old and much better soak vinegar solution thick cloth and put it on the iron and let it sit for a few hours, preferably overnight. Purification iron wipe with a damp cloth to remove the smell of vinegar.
Soda.Soda - abrasive substance, so it should be carefully used for cleaning surfaces. This method is suitable for older models of irons. If there are large pieces of iron adhering tissue, remove it gently with a knife and only then clean the soda.
How to clean? A small piece of cloth and soak the dial on her soda, rub the surface of the iron until all the dirt will not go away. soda remnants rinse with a clean, damp cloth.
Ammonia or peroxide. Peroxide and ammonia are also relatively easy and inexpensive way to clean the iron contaminants.
How to clean? Any of the solutions put on a cotton ball and wipe the soleplate by removing all impurities. Wipe with a damp cloth, and then once again dry.
Also, be sure to find out 15 life hacking for cleaning and cleanliness in the house on all occasions
"
