As you know, Christmas trees is never too much! After all, we need to decorate the house, cook souvenirs and gifts to friends and colleagues still surprise on the job. Today we offer to make a Christmas tree out of paper elements.
we need: Glue (glue gun or PVA), tape, scissors, pencil or pen, cardboard and paper, a new color or colored residues, magazines, unwanted cards, beautiful wrapper and even music! Useful as shaped hole punch and a variety of stencils.
As a master: first make a cone of cardboard on the pattern of previous publication about the fur-tree from ribbons.
Using figure Punch cut out as much as possible of parts of paper of the same size, e.g., bubbles with a wavy edge.
If the figure is no hole punch, use conventional stencil with geometrical figures. Best of all would look circles, ovals, stripes and triangles. Draw using a stencil pieces on prepared paper and cut out with scissors.
It is possible to prepare the whole blocks with fringe width 5-7 cm strips, fringes 7-10 mm.
Screw the parts to stick or tube, to be a little wrapped.
Paste the first row of items in a circle, starting from the base of the cone so.
And so:
Details oval need to stick alternately short side, and triangles - the wide side of the cone.
Details have a closer look to each other, so that in the fur-tree was not "bald patches". So gradually papered base, moving to the top.
Last detail - the circle, rolled into a cone shape. This will be the tip of our trees, instead of the cone can be stuck a star or a bead.
Wonderful 3-D herringbone pattern can be made of paper volume elements. But the time and effort will need a little more.
This design is called paperkraft. Simple stencil is not enough, need a pattern. Simulation-paperkraft allows, unlike origami, use scissors and glue.
Better to take the green paper, but we advise to use other colors and textures, in any case, will turn out interesting and unusual!
In addition, it will need a frame made of wire, on which we will assemble the elements.
Draw with a caliper 20 laps. Origin - 20 cm in diameter, each following half a centimeter less. Inside each circle draw another smaller diameter equal to ½ of the outer circle.
Divide via line 8 at each wheel, and preferably 12 identical sections.
Cut the workpiece by drafted lines from the outer edge to the inner circle. Displace a cone and glue the sides of each cut section. It will be a needle.
Thus we harvest tiers 20, which are alternately, from largest to smallest, strung on the barrel-wire. Tiers must be placed so that the needles interspersed in a checkerboard pattern.
Will tip circle, rolled into a cone shape.
Bottom of the barrel is necessary in advance to make a loop in the form of a spiral, which is adhered to a stable substrate. The base may be cork, wooden cube, a small decorative flower pot or anything else that can provide stability of the construction.
Decorate Christmas tree beads, beads, sequins, buttons, pompons. What beauty has turned out!
Kolobok.ua He advises to prepare a few Christmas trees to enough for everyone - no doubt they will be snapped up!
